Where did you install your OB emblem?

[Rocksylvania]

On the rear door (so folks behind me in traffic / on trail can see it) and on the front grille, like a traditional car badge.

Front:

Back:

Did you just stick it right to the grill or mount it somehow? Mine is mesh and the adhesive won't make much contact. I tried to get a grill badge mounting adapter but it was way to large in diameter and had a convex face for that type of badge.

 

[NightCrawler]

On the rear door (so folks behind me in traffic / on trail can see it) and on the front grille, like a traditional car badge.

Front:

There is something sexy about it being on the front grill...I just might have to get me a third one made up to put it there.

 

[OkieOverlander]

Sent from my iPhone using OB Talk

 

[DeltaZulu]

 

[Smileyshaun]

Front fender , seemed to be a easy place to see it

 

[Rangervinny]

2005 Toyota rav4

#TRD #Rav4

 

[TerryD]

I just got around to putting mine on today. I've been debating about where I wanted out but finally settled on the rear hatch, beside the handle of the Xterra.

 

[Eric Martin]

 

[J Tosh Reed]

Mounted on both sides above the SR5 emblems

 

[Sebastian Stonum]

I thought long and hard about this

 

[Tommys]

Just got mine!

 

[Scrfn73]

Got mine the other day, and installed on driver side fender.

 

[AAONMS]

Am considering removing the ‘Trail Rated’ medallion from my Jeep and replacing it with the OB one.

 

[ALL 4 Overland]

I have had my emblems for a few weeks and have been debating where to put them and have decided on the drivers side and passenger side door pillar...as the whole of my truck is raptor lined these are the few places i could actually stick them...but you do see them everytime you get in the truck..

 

[NightCrawler]

I have had my emblems for a few weeks and have been debating where to put them and have decided on the drivers side and passenger side door pillar...as the whole of my truck is raptor lined these are the few places i could actually stick them...but you do see them everytime you get in the truck.. View attachment 41647

Perfect spot!!! Looking good brother!

 

[FireMedicPQ1]

These are all amazing ideas. I hadn't installed my badge yet. Was thinking on an interior mount (as some of you have done). What has been everyone's experience with the exterior mount - is the sticky tape strong enough to keep it from falling off after being exposed to heat/cold/wet/dry?

 

[Mlbdriver]

 

[Ronin910]

Both front fenders next to the Ram Charger badge. View attachment 6037

How well does the emblem adhere to the bedliner paint? curious because My truck is raptorlined

 

[Kent R]

 

[PetfishEric]

How well does the emblem adhere to the bedliner paint? curious because My truck is raptorlined

As long as the surface is clean when you install it you can't pull them off. I just sold the Ramcharger and had to use a heat gun and screw driver to pyre them off and they pulled some liner off still. Now I have to figure out where to put them on my 1st gen Tundra.