-
Guest, UPDATE We went through the site migration runbook and completed all steps. We will need to complete the migration next week, but will leave the forums up for the weekend. A few days after maintenance, a major upgrade revision to the forum site will occur.
-
What Did You Do With Your Rig Today?
- Thread starter iamout
- Start date
Trail Blazer III
I just added some lights to the front and back of the truck.
Pathfinder I
It turned out really clean. Nice work!
Member III
Getting tired of pushing snow with the bumper 
So I did a little trimming , still need to do a little more shaping and then paint it black after I get the fog lights remounted to it but hoping it will help
So I did a little trimming , still need to do a little more shaping and then paint it black after I get the fog lights remounted to it but hoping it will help
Explorer I
Man, that turned out great. Great design!
Pathfinder I
I finally got an alignment! It's been 3+ months since I installed the aftermarket UCAs but I've been working on getting my front suspension set where I want it so no sense in wasting money on an alignment until that was done.
Looking at the before numbers the UCAs added quite a bit of caster and toe but I was still having trouble rubbing the rear of the wheel well after adding the 1.00" wheel spacers. The tech at Less Schwab was great and he let me go into the work area to discuss my desired outcome. We ended up pushing the wheel as far forward as possible. It's easier to make room in the front of the well than the rear.
During my alignment last summer before the UCAs we set caster at 2.9 and 3.1.
Looking at the before numbers the UCAs added quite a bit of caster and toe but I was still having trouble rubbing the rear of the wheel well after adding the 1.00" wheel spacers. The tech at Less Schwab was great and he let me go into the work area to discuss my desired outcome. We ended up pushing the wheel as far forward as possible. It's easier to make room in the front of the well than the rear.
During my alignment last summer before the UCAs we set caster at 2.9 and 3.1.
Member II
That came out impressively well. Great job.
I've been tempted to do something similar to my Pajero, using the below photo as inspiration. - haven't worked up the guts to hack away, though.
Advocate III
I need this in my life... I keep forgetting to apply for it, then forget how to apply, it’s a viscous cycle.
Baipin
Rank IV
Enthusiast III
Thanks guys! It was one of my first major projects after getting back into welding. Stick was a little cumbersome for the smaller parts... but now I have a good excuse to learn TIG if I do a front bumper too.
Member II
Making some good progress on the new build. AirLift 5000 airbags installed. More parts going on tomorrow and Tuesday. [emoji16]
Explorer I
Looks good!
Advocate III
Talk to me about your recovery boards... brand, where you got them, and will they work as a bridging device?
Baipin
Rank IV
Enthusiast III
Looks great - Love that orange colour and the rack is very clean. Tundras are fantastic trucks. I learned to drive on a Sequoia (same truck, different body, I think)?
Off-Road Ranger I
Today’s job is training! Practicing putting tire chains on and taking them off so I can do it quickly if needed.
Dustinfromohio
Rank III
Enthusiast II
Wire loomed new winch wiring to prevent rubbing, continued tearing apart the off-road trailer.
