Enthusiast III
Labeled the main switch panel and cleaned up wires for the trailer
Attachments
-
51.9 KB Views: 86
Enthusiast III
Enthusiast III
Influencer III
19540
Wow, they are proud of their products!I finally installed the Raingler “attic net” up over the back seat of the Frontier. It looks like it’ll be a good place to tuck a jacket or my hat when the back seat ends up full of other stuff. No picture yet, gotta get one.
Enthusiast II
Member II
20275
Just camped at a friend's place on Wolfpit at the base of Shortoff this weekend..How bout that wind Friday and Saturday?Went snow wheeling with a friend, turned into ice sliding. Pinballing down the mountain caused a little damage. Friends rig was good, so I get to hammer out metal and replace a taillight. Good times.
It sure blew cold on top of the gorge.Just camped at a friend's place on Wolfpit at the base of Shortoff this weekend..How bout that wind Friday and Saturday?Went snow wheeling with a friend, turned into ice sliding. Pinballing down the mountain caused a little damage. Friends rig was good, so I get to hammer out metal and replace a taillight. Good times.
Member II
20275
Enthusiast III
Member III
17011
Member II
Member II
20275
Nice rigs!(Sunday) Led a group of 28 people through some N. GA roads!
Off-Road Ranger I
27152
Member III
Member III
17011
Looks good though!
Member III
Thanks it saves me the trouble of fabbing up rear bed sliders. next up wil be drilling the frame for the sliders i built and putting them on. It should be nearly complete after that, just need a trans skid though I may have to make one myself haven't found anything I really like yet.Looks good though!
Enthusiast III
Enthusiast III