• Guest, UPDATE We went through the site migration runbook and completed all steps. We will need to complete the migration next week, but will leave the forums up for the weekend. A few days after maintenance, a major upgrade revision to the forum site will occur.
  • HTML tutorial

What Did You Do With Your Rig Today?

denw

Rank V
Launch Member

Pathfinder I

Finally got my Nitto Ridge Grapplers put on along with some Bilstein 5100s front and back. Removed the 2" rear blocks and put in the factory 1", added a 2.5" level kit to the front took the rake from 2.5" to 1". New ball joints UCAs and replaced the left front hub assembly... Rides so much better,20190318_084759.jpg now she needs a bath bad ;)
 

KirkB

Rank III
Launch Member

Advocate I

That is the exact setup I want to install on Red Five.
Was really straight forward; only issue was the factory fogs prevented the winch from lining up with the bolt holes. Looking for some lower profile lights.
 

Lost-Again

Rank V
Launch Member
Member

Enthusiast III

I installed some BajaDesigns S2s on CaliRaised low profile mounts. But the cheapie switch already gave out. I’m going to install the Baja switch into the blank cover.
 

Attachments

Magic Mike

US Full-time/Long Term Travel Ambassador
Launch Member
Member

Expedition Master I

Part II- bottom wood deck cut to size and top desk cut as well. Not sure yet if I want to build a frame and add sliders to the Ammo boxes. I’m happy with the way it is for now. I can carry all of our camping gear in the back as well as tow recovery gear and misc auto box . Up on top I have a fridge, folding table, two sleeping bags, two folding director chairs, 5lb propane tank and a small jack. The only thing left to pack is the dry good box and our back packs with a change of cloths. View attachment 89792View attachment 89793View attachment 89794
What a great idea, that looks great..
 
Top