Off-Road Ranger I
Oh, it's not that bad. He's just been my mascot for a couple of decades and started as a "news reporter".
-
Guest, UPDATE We went through the site migration runbook and completed all steps. We will need to complete the migration next week, but will leave the forums up for the weekend. A few days after maintenance, a major upgrade revision to the forum site will occur.
-
What Did You Do With Your Rig Today?
- Thread starter iamout
- Start date
Influencer III
It was a bubble headed beach blonde?
Off-Road Ranger I
Close, but no Don Henley.
Actually found it. Can't believe it's still out there after all this time.
Member III
ThundahBeagle
Rank V
Advocate I
Hauling 900 lbs of early 1900's era brick left over from a demo. Plan to use it for a herringbone platform in front of a shed that I hope to turn into a sauna. There is a wooden deck platform there now that's wet-rotted. Dont want to replace it twice in my lifetime.
Here's the shed last winter:
Here's the shed last winter:
ThundahBeagle
Rank V
Advocate I
Hard to say which I would like more, TBH
Enthusiast III
5 months later, and phase 1 is complete. Now I've got to develop phase 2.
Off-Road Ranger I
The Collie is her daily, but she did drive the BS on half of the Hill Country Route yesterday. I might not get it back now. LoL
Steward II
I put my rack on this week to go camping and my back power panel I installed a couple years back was dead. Took about 4 hours of troubleshooting to find that a butt connector had corroded from moisture infiltration due to my poor weather insulation. The entire black heat shrink was full of green corrosion and it was losing over 7v at the junction. So I replaced this piece and everything was back on track, but due to the delayed start we stayed at a campground which is not at all normal for us. But still fun! We put our heater (it is North Idaho) and our PullKitchen to use again.
Also I got in the new 5 gallon Rotopax which fits perfectly on the back of my PullKitchen. It was built to hold two 2 gallon units, so it’s now just one tank and adds an additional gallon.
Also I got in the new 5 gallon Rotopax which fits perfectly on the back of my PullKitchen. It was built to hold two 2 gallon units, so it’s now just one tank and adds an additional gallon.
Last edited:
Member II
Washed her up and took her picture,.
Zim
Zim
Dave, Glad you found the issue, It’s the little things! Loving the 5 gallon Rotopax, going to have to get one for my PullKitchen!
Steward II
I was gonna do an elbow piece for the pick up line and then got lazy and just used a heat gun to create more bend in the pick up. Haha
Advocate II
I was thinking of starting a thread for my slow and bumpy progress on my truck...seems like this thread would be hijacked as I have a lot going onbut not sure of a better spot? advice on forum etiquette? best way to go about it? thank for your patience.
Explorer I
The fact that you asked shows a lot! There is a section for build threads. I started mine about 10 months ago and just kept adding to it! It does take time and more effort than I expected trying to “pause” to take pictures while trying to accomplish a task. Best O’luck!
Member II
winching again. Yeah, in the yard. I use it more at home than anywhere. LOL
Zim
Zim
Enthusiast III
Spent the weekend making progress on my new camp cooking drawer. I still need to get the pump, plumbing, and electrical lined out so I can get the shell on and painted but I'm eager to get it back into the Xterra and get back out there again.
