Enthusiast III
I always try and clean up the car best I can before taking it in for service just as a curtesy for the shop to hopefully make their job a little easier.
Chevrolet Suburban 2500 Overland Build
- Thread starter Neon Paradise
- Start date
I always try and clean up the car best I can before taking it in for service just as a curtesy for the shop to hopefully make their job a little easier.
Enthusiast III
While cleaning up the engine bay, I noticed that some of the wiring conduits were getting pretty brittle. So I bought 10ft from AutoZone and replaced what I could. What a pain!
Enthusiast III
Enthusiast III
Finally had time to take the Suburban to the shop to have the auxiliary lighting rigged up. I went with an AuxPower 6-Gang Control from Amazon. It seems to be decent quality, but I would have liked to have found a unit that could support a higher amp load. One of the 10 amp terminals got messed up as well with little pressure.
It works well and has an auto-dimming sensor so that its not distracting at night.
Enthusiast III
Enthusiast III
I had them wire up the five on the light bar as one, the two 100w Hellas on the front bumper as one, the two front side cubes as one, and two rears as one. I like the setup and I'm pleased with the light output.
Enthusiast III
Enthusiast III
Enthusiast III
Got the whip antenna and mount all setup! The tie-down point fit perfectly between two light housings on the lightbar. I used a ziptie just as a precaution to prevent the antenna from backing out on its own.
Enthusiast III
Since then, I have angled the mount slightly more inwards so that it doesn't arc as high as in these pictures.
Enthusiast III
Enthusiast III
Ended up removing the lower air dam like ThundahBeagle suggested previously. Haven't noticed any drop in mpg or cooling issues.
Enthusiast III
Influencer III
- 4,312
- First Name
- Rex
- Last Name
- Drake
- Member #
19540
- Ham/GMRS Callsign
- KI5GH
- Service Branch
- Air Force
I had taken the air dam off thecopcar before I left it behind some place. I get an occasional chin scratch.
Enthusiast III
Yeah luckily new bumper covers aren't much for these and black is easy to match if theres any major damage. I'm looking to see if they make a metal version of that plastic skid plate that you can see in your picture.
Influencer III
- 4,312
- First Name
- Rex
- Last Name
- Drake
- Member #
19540
- Ham/GMRS Callsign
- KI5GH
- Service Branch
- Air Force
Enthusiast III
Today I decided to tackle the sound dampening material that I ordered through Amazon. I bought two 10 packs of 14.5x10. Each pack weighs 7.3 pounds. It was easy to cut down and the adhesive worked well.
I did both rear wheel wells, the underside of the slide out tray, part of the rear roof, and all four doors. I can definitely tell the difference and I'm pleased with the results vs the cost.
