Expedition Master II
That's where I'm thinking of putting mine....
Where did you install your OB emblem?
- Thread starter Alex_Kulbaka
- Start date
-
- Tags
- badges emblems membership placement
Enthusiast III
It'll give that trd pro emblem a nice pop [emoji106]
Traveler I
Traveler I
You don’t have enough stickers though
Traveler I
Any suggestions for new stickers??
Traveler I
Which stickers. I keep rotating them out as previous ones get worn out
Traveler I
B A O R it’s a group in VA stands for badass off-road! Pretty cool group of guys!
Expedition Master II
Yep I think it gives the emblem a little pop. I even washed the car for the occasion
Off-Road Ranger I
Finally got my emblem #13713. Which is crazy since I saw someone post their badge #5000 something in just March 2017! This community is growing fast.
So I went to Home Depot and spent a good 30 min in the hardware section brainstorming how to do this.
Here’s all the parts I got
I found something called an elevator bolt (middle bottom of the picture above) which was perfect. A large flat head. It honestly would have probably been just fine by itself with a washer on the back but I wanted more to contact the 3m adhesive so I got some of these rubber washers
Then I got a ring washer to push on the rubber washer but not the elevator bolt because the elevator bolt has a slight taper on the underhead
Then I went a little overkill. I put fender washer so there would be pressure on the large ring washer and the bolt. And then I wanted only rubber to contact the grill
Then it was just a rubber washer, fender washer, and a wing nut for the back
Hopefully it all stays together.
So I went to Home Depot and spent a good 30 min in the hardware section brainstorming how to do this.
Here’s all the parts I got
I found something called an elevator bolt (middle bottom of the picture above) which was perfect. A large flat head. It honestly would have probably been just fine by itself with a washer on the back but I wanted more to contact the 3m adhesive so I got some of these rubber washers
Then I got a ring washer to push on the rubber washer but not the elevator bolt because the elevator bolt has a slight taper on the underhead
Then I went a little overkill. I put fender washer so there would be pressure on the large ring washer and the bolt. And then I wanted only rubber to contact the grill
Then it was just a rubber washer, fender washer, and a wing nut for the back
Hopefully it all stays together.
Member III
Member III
Not very original, but works! My dog Lilly liked it! Benz.
Enthusiast III
One on each side!
Steward II
Explorer I
Looks factory installed.....almost like it’s the Subaru Outback Overland Bound Edition!
Traveler I
So where did you install yours? Let's see it!
