Member III
Drove it to Church, then to a hike
-
Guest, we will be conducting site maintenance this week and some downtime is expected. At this time Rally Point and the Member Map will also become an app-only feature for long-term security and stability. A few days after this maintenance, a major upgrade revision to the forum site will occur.
-
What Did You Do With Your Rig Today?
- Thread starter iamout
- Start date
Member III
Nice mating partner. Anxious to see what the kids look like LOL
Member III
Advocate I
Worked on the WJ for a moment before dark tonight. Pulled timing cover. Glad I did. Right and left cam tensioners now on order. All else looks fine. But in better news, my custom heavy duty stainless diamond plate brush guard for the Tahoe just arrived! Time to replace cheap plastic with serious strength! Just need to add the holes for the mounting bolts..... unfortunately it will have to wait as I have my hands full with the WJ right now.
Member III
Got to finally try out my traction boards 
Contributor II
I put a new floor pan in my jeep cj5 project today!
Member III
Poor Bronco, you know it is going to get even with you if you dont give him his needed attention.
Member III
Good start, do you have to replace the front pan too ? Hows the frame on the old girl ? Whats your goal, not a plow I hope.
Contributor II
The running gear is great, just alot of bodywork. The plow is coming off and I plan to do the Trans America Trail when she is done.
Member III
I've heard it's a good trek. Is your engine the 4 or 6 cylinder model. All my friends did sb Chevy's in theirs but I love both the 4 and 6 cly models, even the old flat heads are neat and very dependable. What year model is your Jeep ?
Member II
After modifying(shortened 3"), sanding, priming and applying bed-liner to the ladder-rack, I installed the front frame.
I'll need to relocate the GMRS and CB antennas.
If the weather cooperates, I hope to complete the modification of the rear and side supports this week. Once that's done, I'll be able to install a cross-bar to install the RTT.
I'll need to relocate the GMRS and CB antennas.
If the weather cooperates, I hope to complete the modification of the rear and side supports this week. Once that's done, I'll be able to install a cross-bar to install the RTT.
Advocate III
I ordered the rest of my electric stuff today for the old girl... it should start filtering in by the end of the week. So it will get some love
Member III
Cant tell where you cut them. Good job Mike. Sure like that garage too.
Enthusiast III
Spent the day welding on brackets and getting the new awning mounted to the truck. Glad I went with the 8 foot one. Sets up super easy and so does the room.
Member III
I like your setup. Any info on make and model you can give ? Not a lot of need for a tent with your setup. Is there a wall next to the truck too ?
Enthusiast III
It is the ARB 2500 awning and their room add on. Walls on all 4 sides, floor and ceiling. Great setup, I'll be using it for a hang out room, as my rtt is comfy, and the wife likes sleeping off the ground lol. I'll attach some photos of inside. All 3 faces showing have screen doors the side on the truck does not, it just zips around so you can access the truck from inside. The side on the truck has zippers in the upper corners, guessing for vents and to pass power cables through from truck, and the whole inside is lined on the roof with hooks to hang items from. Also comes with a small hanging closet to put items in, it hangs from hooks on either back corner.
