Expedition Master I
- 5,079
- First Name
- Drew
- Last Name
- Hawley
- Member #
-
1537
- Ham/GMRS Callsign
- WRBZ674
- Service Branch
- USN veteran
What Did You Do With Your Rig Today?
- Thread starter iamout
- Start date
Snow arrives here in the Rockies..
View attachment 8903
View attachment 8903
Missed the interior LED lights from my 2012 Ford Focus SE Sport and finally put them in the 2015 Jeep Wrangler Unlimited Rubicon Hard Rock, only took a year and half, way better with the Putco Kit.
Late start today then I had to run around looking for Deutsch connectors for the lights. Front bumper is painted and mounted. Wired up the d2's, a-series, and resistors. Signals blink at regular speed, so that's nice. Tomorrow will hopefully have the 240's, winch, and front plastic completed
Influencer I
Put a magnetic mic clip on my CB for this weekend's run. Also installed a Synergy track bar bracket on my JK! What's next???
View attachment 8981
View attachment 8982
View attachment 8983View attachment 8984
View attachment 8981
View attachment 8982
View attachment 8983View attachment 8984
Last edited:
Yep. Forgot to upload before I posted. Thanks for the reminder!
Traveler III
- 4,002
- First Name
- Kelly
- Last Name
- Herrin
- Member #
-
2032
- Ham/GMRS Callsign
- KFØDEX
Did some preventative maintenance this morning. Flushed the cooling system, and replaced both heater hoses (did I mention that one of them had started to split? ;-)
Installed NVIDIA Shield Tablet & RAM Mount For Back Country Navigation
Not happy with the suction mount, so today or tomorrow I will be trying out the RAM floor mount I picked up also.
https://www.overlandbound.com/forums/threads/coreys-2007-toyota-fj-cruiser-build.2257/page-5#post-47025
Not happy with the suction mount, so today or tomorrow I will be trying out the RAM floor mount I picked up also.
https://www.overlandbound.com/forums/threads/coreys-2007-toyota-fj-cruiser-build.2257/page-5#post-47025
Was heading out for the weekend. Heard loud clunking noises. Stopped and road and noticed the driveshaft was rubbing against the fuel tank skidplate. Took skid off and drove home. Cut off the rubbing part and trying to fit it back on. The loaded weight brought the driveshaft too close to the skid. Pack light gentlemen. This is cold reminder
Pathfinder I
At Canopy World getting a LEER locker installed. Like the secure storage it'll give me. That's today -- tomorrow? Who knows!!!! [emoji33]
Advocate II
Off-Road Ranger I
- 2,771
- First Name
- David
- Last Name
- Goodyear
- Member #
-
0691
- Ham/GMRS Callsign
- KL7JKC
Definitely check your U-joints, pinion yoke play and slip joint slop, be it a transmission slip joint or drive-shaft slip joint. That kind of noise should not be loud against a skid plate unless something else is swinging pretty wide.
Off-Road Ranger I
I decided to see what may truck looked like in tan instead of green. 
View attachment 9071 View attachment 9072
View attachment 9071 View attachment 9072
had a little body work done on my Suzuki over the weekend, the rear spoiler had a crack in it and the rear bumper cover was starting to lift. I also wanted to add a lift assist bar to help with keeping the figure prints off the car.View attachment 9080 View attachment 9081 View attachment 9082 View attachment 9083 View attachment 9084
I installed two new lights up top, just in time for our trip to Missouri
