Re-fueling from your Gerry can

  • Thread starter Deleted member 82267
  • Start date
  • HTML tutorial

grubworm

Rank V
Launch Member

Member III

2,358
louisiana
First Name
grub
Last Name
worm
Member #

17464

Service Branch
USN-Submarines
oh, like nobody has ever been out in the middle of nowhere and spilled a little gas on "accident"...

1649772468507.png
 
  • Haha
Reactions: Ubiety

pluton

Rank IV

Member I

951
Santa Monica, CA, USA
First Name
Keith
Last Name
BBB
Member #

43443

I use this type of nozzle on jerry cans. I use the plastic part shown at bottom to add approx. 20" of fuel hose, which, when filling, is pushed down into the vehicle's filler hole. Never spilled or even dripped, except once when I didn't hold the jerry can correctly and it blurped some gas out the vent tube.
Screen Shot 2022-06-02 at 22.43.29.jpg
 
  • Like
Reactions: Red_Leaf_Overland

ThundahBeagle

Rank V

Advocate I

1,548
Massachusetts
First Name
Andrew
Last Name
Beagle
Member #

0

Practiced filling a non-jerry can, new Midwest Can company model 5610, 5 gallon plastic gas can. Fueling the truck with it a couple weeks ago, the stupid safety nozzle made it so difficult. The pressure from the lip of the truck filler neck is supposed to push back on some sliding safety valve to allow the fuel to run.

What a mess.

And to top it all off, my gas cap no longer "clicks" when I close it. It most likely isnt damage to the cap, as that was out of the way. So something got smoothed out on the lip of the filler neck, I'm guessing.