Well I broke down and ordered the Sherpa 56'' rails and feet for my shell and have an Overland Vehicle Systems awning enroute after watching the videos about them here. I will post once it is all here
Well this will be the last post here until we get some cooler weather to get out and go camping. I have added 3 Sherpa load bars and an Overland Vehicle Systems 270 degree awning.
So went back to the drawing board and decided to rebuild the base cabinet so that it will fit between the wheel wells from front to back. I plan to build out a face plate over the front and tie this into the tiedown points in the front and the rear of the bed. I think this will work out best. It will also provide a totally enclosed drawer to help limit any dust from getting in them by using felt seals. I am no cabinet maker so I was pretty excited when I stayed within a 1/16th of inch between the two drawer cavities. I glued and screwed all of the panels together using waterproof glue and Kreg pocket hole screws. The front area will be for the utility stuff like 21 gallon water tank and on demand water pump and power management.View attachment 224913View attachment 224912
Hi Guest, Become a Member to gain access to the Member Forums, Member Map, Member Calendar of Events, and Rally Point overland trip planner! Click this link Learn More for more information!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.