2001 Land Rover D2

[Gabriel Bozeman]

Got new adhesive and put my emblems on today, my kids picked the spot. View attachment 90210

Looking good!

 

[Gabriel Bozeman]

Let's see it! My brother had a RRC that's what got me started, if I didnt need the 7 seats I'd have a p38 rover.

Here he is! It's a 30th Anniversary Edition, which means only 200 or 300 made worldwide.

 

[Gabriel Bozeman]

Let's see it! My brother had a RRC that's what got me started, if I didnt need the 7 seats I'd have a p38 rover.

I wanted a Disco back before knowing anything about Land Rovers. I couldn't find one so went with the P38. We have loved it so much.

 

[MattAnderson1986]

Time to fix the sagging rear and make this a full 4 inch lift. I have 4 inch front springs and 3 inch rear.

 

[Gabriel Bozeman]

Time to fix the sagging rear and make this a full 4 inch lift. I have 4 inch front springs and 3 inch rear. View attachment 90224

Where did you get your lifts? I'm thinking about listing my Rover.

 

[MattAnderson1986]

Where did you get your lifts? I'm thinking about listing my Rover.

My lift is an rte 4 inch

 

[MattAnderson1986]

Full 4 inch done.

 

[Gabriel Bozeman]

My lift is an rte 4 inch

Thanks!

 

[MattAnderson1986]

Adventure time..

 

[Gabriel Bozeman]

Adventure time..View attachment 91165

Sounds awesome!

 

[MattAnderson1986]

Tire day!

 

[Gabriel Bozeman]

Tire day! View attachment 91357

Ooooo, what kind?

 

[MattAnderson1986]

Ooooo, what kind?

Milestar Patagonia mt 285/75/16

Super happy with them so far they are very quiet, and for $600 I'll give them a shot.

 

[MattAnderson1986]

Mounted up, super quiet for a mt tire and half the cost.

 

[Gabriel Bozeman]

Milestar Patagonia mt 285/75/16

Super happy with them so far they are very quiet, and for $600 I'll give them a shot.

Awesome!

 

[MattAnderson1986]

Found my t case leak! Front seal was bad.

 

[disco_unchained]

Found my t case leak! Front seal was bad. View attachment 92005

Would love to know how far down you put the new one. I just replaced the front output bearing on mine to eliminate vibration, put a new seal in with it, and now I have a leak (didn’t before). I ordered another seal and will be doing it over again this weekend. I pushed it all the way down to the circlip and think that might have been too far to get a tight fit with the flange.

 

[MattAnderson1986]

Would love to know how far down you put the new one. I just replaced the front output bearing on mine to eliminate vibration, put a new seal in with it, and now I have a leak (didn’t before). I ordered another seal and will be doing it over again this weekend. I pushed it all the way down to the circlip and think that might have been too far to get a tight fit with the flange.

I seated it all the way down, I used a Brit part seal

 

[MattAnderson1986]

Almost ready for my big trip, Michigan to Oregon. Control arm bushings in the morning.

 

[MattAnderson1986]

What a pain!