Member III
Bought this to drive around as a ride tell my 95' Jeep Cherokee is drivable again. Going to leave it as it is. It is already lifted 3" and running 32x10.5x15s, tube bumpers front and rear, new Warn manual hubs. Fun rig to drive! Benz.
89' Nissan Pathfinder, no build!
- Thread starter 4wheelspulling
- Start date
FeralBoy
Rank 0
Traveler I
As long as you keep the timing belt change it should last forever
Sent from my SM-G930V using Tapatalk
Zerobird
Rank IV
Traveler I
Even if the t-belt breaks it's a non interference engine, can align it all back up put a new belt and tensionor good to go. (3.0 V6) the (2.4 is a chain, not sure if the valves & pistons will high five each other)
OP, congrats on the rig, I had an 89 pickup 4x4 3.0, it had over 250k before I got rid of it for a 04 Supercharged Frontier. I got rid of of it before it hit 90k, the hardbody was far more reliable.
maxfederle89
Rank IV
Pathfinder I
That's thing is cool! Had an aunt that had one when I was little. I would ha e looked into them if there was a clean one before I found my Jeep WJ.
Sent from my SM-J320V using Tapatalk
Sent from my SM-J320V using Tapatalk
Member III
I got a good one too. This had lots of work just done to it , with the timing belts done. I do wish it was manual trans., but so far the auto trans. works fine, shifts fine. I plan on adding a good trans. cooler and trans. gage to watch the temp. 247k on the truck! LSD in rear axle needs new clutches, but all in all runs out great! Thank you for the congrats on this rig! Benz.
