Hi All,
I wanted to share with you the latest (today :-)) build I did.
For those with the rear coffee (or anything else) table at the back door you probably applied some kind of light solution.
Well it took me some time but today I decided to install LED light on the back glass part of the door so when I open it up and turn on the LED it will light my kitchen area.
So this is how the back of my Jeep looks like :
View attachment 171491
So the idea was to put the LED as marked here :
Blue = where to locate the LED light (from the inside)
Yellow = the light when turned on :-)
View attachment 171492
So I took the following simple kit of LED strip :
View attachment 171485
*** I didn't use the cable to connect to the lighter plug , I connected it to one of the power lines coming from the battery
So work begins :
View attachment 171486
Putting the LED light strip (from the inside)
Now attaching the power cable to the window using 3M stickers and special cable carrier :
View attachment 171488
Sorry not the best picture but I hope you get the point.
I have used the rear cables tunnel to pass my power line so no cables will fly around in the inside of the back of my jeep
View attachment 171487
And from the inside :
View attachment 171489
From there under the cover to one of the + and - cables I had there so power is available
Now I have light when needed :-)
View attachment 171490
Thanks for reading ,
Ramon
I wanted to share with you the latest (today :-)) build I did.
For those with the rear coffee (or anything else) table at the back door you probably applied some kind of light solution.
Well it took me some time but today I decided to install LED light on the back glass part of the door so when I open it up and turn on the LED it will light my kitchen area.
So this is how the back of my Jeep looks like :
View attachment 171491
So the idea was to put the LED as marked here :
Blue = where to locate the LED light (from the inside)
Yellow = the light when turned on :-)
View attachment 171492
So I took the following simple kit of LED strip :
View attachment 171485
*** I didn't use the cable to connect to the lighter plug , I connected it to one of the power lines coming from the battery
So work begins :
View attachment 171486
Putting the LED light strip (from the inside)
Now attaching the power cable to the window using 3M stickers and special cable carrier :
View attachment 171488
Sorry not the best picture but I hope you get the point.
I have used the rear cables tunnel to pass my power line so no cables will fly around in the inside of the back of my jeep
View attachment 171487
And from the inside :
View attachment 171489
From there under the cover to one of the + and - cables I had there so power is available
Now I have light when needed :-)
View attachment 171490
Thanks for reading ,
Ramon
