FOR SALE Custom drawer system for 5th gen 4Runner

[Derbydude]

Custom drawer system for 5th gen 4Runner, fridge slide, stove storage, two drawers, plus gear storage. Anderson plug to disconnect the fridge and I’ve installed a drag chain to control the power cord when sliding the fridge out Not shown in the picture. Secured with 4 turn buckles to factory tie down points for easy removal, you will need to have power for your fridge run to the back of your vehicle and I’ve designed this system around the ARB 45 quart fridge freezer.
I’ve included pictures of the actual system for sale plus two of the prototype in my own Runner.
Asking: $ 2,000
I’m in Santa Rosa California and can can deliver in the Bay Area but would prefer you come get it at my shop so I can help install it.
I’m also available to do custom orders, and can design drawer systems for other vehicles, prices will vary.

 

[lebell9058]

Hi! Great work, beautiful details. Could you post dimensions?

 

[Derbydude]

The base is, front to back: 34 1/8”
Side to side is: 41 1/2”
Drawer area, front to back: 31 1/8”
Side to side: 22 1/8”
Fridge area, front to back: 31 1/4”
Side to side: 18 3/4”
Inside dimensions where the fridge will fit is, front to back: 28”
Side to side:17 3/4”
Hope this help, like the description says it’s for a 5th gen 4Runner that doesn’t have the sliding floor, I can also custom build a drawer system for you too

 

[Derbydude]

Hi! Great work, beautiful details. Could you post dimensions?

I’m not sure if I sent the dimensions to you but they are up in the feed now

 

[Jason_Over4Runner]

I am in the process of doing a very similar set up right now. I have been amazed at the material costs. I am $800 deep just in material and looking at what you've done yours is probably even higher. There is definitely a reason a good drawer system cost so much.