2nd Generation Tacoma built

[French]

New project, 2012 TRD T/X baja series 4x4. I need suggestions on modifications and upgrades

 

[French]

New rubber 265/75/16 BFG AT KO2's, Much better tires than the Invovic's for sure.

 

[French]

Tacoma TRD TX Baja update: Factory Roof Rack, Running Boards and Skid Plate.

 

[French]

Upgraded Engine splash guards to Gear Tech-ProTec Splash Guards for 12-15 Tacoma, these are very heavy duty and very well made product and easy to install.

 

[French]

Upgraded Engine splash guards to Gear Tech-ProTec Splash Guards for 12-15 Tacoma, these are very heavy duty and very well made product and easy to install.
View attachment 65797 View attachment 65796 View attachment 65795 View attachment 65794
View attachment 65793View attachment 65794

These are great to replace old factory ones that fall apart when you look at them.

 

[French]

Added bike mount and quick fist mounts for a shovel.

 

[French]

Added Softopper, very easy to install and happy with quality.

 

[French]

Rain update on the Softopper, Ii does leak a little I need to back over and seal the seams again and adjust it a bit and it should be good.

 

[French]

Haven’t done much to this rig lately $$$ is always the constraint, but I did take off all the chrome badges and paint grill shell and put a second hand factory TRD PRO grill insert and a new matching tire on my spare.

 

[French]

 

[French]

These are paints I used to paint the grill surround.

 

[French]

View attachment 102111 These are paints I used to paint the grill surround.

I did find if you use this bed coat use half a can for the first couple coats then use another fresh can to finish, this will make the texture more even. Save the the half cans for another project first coats.

 

[French]

Added bike mount and quick fist mounts for a shovel.View attachment 72261View attachment 72262View attachment 72263

Removed mud guards

 

[French]

Added bike mount and quick fist mounts for a shovel.View attachment 72261View attachment 72262View attachment 72263

RockyMount HotRot bike rack mount

• Hard mount bolt-down to carry thru-axle forks. Includes all three popular axle standards,12x100mm, 15x100mm, and “Boost” 15x110mm thru-axles.
• Carries 1 bike, up to 35 lbs
• 15x150mm sleeve sold separately to carry RockShox Bluto or other 15x150mm forks.
• 9mm dummy axle can be purchased separately allowing you to carry a quick release fork.
• Track hardware available separately for track mounted applications
• Footprint measures 4.5” long, 1.6” wide and to the center of the through-axle sits 2.6” above the bottom of the base
• Do it yourself bolt on installation, No mounting hardware included
• Axles can be swapped with set screws. If frequent axle change is required, see the DriveShaft HM, fits both 15x100 & 15x110 without axle change.

 

[RoarinRow]

Looks like you’re ready to roll as is.

 

[French]

Looks like you’re ready to roll as is.

Thanks, yeah it is ready I’m just trying to get time to get out and use this rig.

 

[RoarinRow]

Thanks, yeah it is ready I’m just trying to get time to get out and use this rig.

I hear ya same here.