Getting started on this build. Need a wiring harness for the drivers side front door. If anyone can help me find one it would be greatly appreciated. Here's what the previous owner did to the door wiring.
1993 Land Cruiser
- Thread starter SGT1215
- Start date
Getting started on this build. Need a wiring harness for the drivers side front door. If anyone can help me find one it would be greatly appreciated. Here's what the previous owner did to the door wiring.
Pathfinder III
Hmm... I think I've seen this movie. Make sure to cut the yellow and pink at the same time, otherwise you'll be wiping your butt with a stainless steel hook. LOL
What are your plans for her?
What are your plans for her?
Expedition rig. Been wanting a LC for a while now. Found a wiring harness so I won't have to worry about not cutting the blue wire or any others. Haha! The fun is just beginning. Will have to replace tires as we found dry rot.
New wheels. One step at a time
Next week, rear seal replacement, then timing belt cover gasket. Tune up (need better mileage than 9.75). New wiring harnesses are in just waiting on window controls and bezel to come in.
Next week, rear seal replacement, then timing belt cover gasket. Tune up (need better mileage than 9.75). New wiring harnesses are in just waiting on window controls and bezel to come in.
Digging the NASCAR wheels! Taking good shape [emoji106]New wheels. One step at a time
Next week, rear seal replacement, then timing belt cover gasket. Tune up (need better mileage than 9.75). New wiring harnesses are in just waiting on window controls and bezel to come in.
New wiring harnesses in all 4 doors and the new in dash wiring harness. The previous owner butchered all of these harnesses. It was Texas Chainsaw Massacre in there along with amateur hour. But we are getting there. We have redone the rear seal, timing chain gasket and the valve cover gasket. And! Fixed the stereo. Just about there.
Off-Road Ranger I
Off-Road Ranger I
So sorry you have to deal with THAT (kind of got sick to my stomach looking) more like a seen from a horror movie!!!!!
Getting started on this build. Need a wiring harness for the drivers side front door. If anyone can help me find one it would be greatly appreciated. Here's what the previous owner did to the door wiring.
Member III
Advocate II
While putting the last bolt on the driver front hub I broke the bolt off then I broke the extractor off in the hole. Had to take that in and have a shop drill it out. It appears it was amateur hour in the hubs too. Found what appears to be silicone to keep the hubs from leaking. The passenger hub had a bad seal due to a screwdriver used to pull out the old axle shaft seal. Finally have the hubs done. I'm on a first name basis with the parts guys at Red McCombs Toyota. One last part to finish them up. Oil pan gaskets are next, then the oil pump o-ring AC compressor later in the Spring. Then to finish the wiring and install lights and a new stereo (thanks to my lovely wife's Christmas present). Once that's done, repair the seats and then to start the fun stuff with new bumpers, a lift etc. Its been challenging but a great deal of fun. Thank you YouTube for the how to videos!!!!
