Looks great
I am in the process of doing something similar. Is there a reason you did not run the wires that go up into the bed, through the stake pocket hollow, instead of up through the bed floor? I am thinking of using the stake pocket tower to get my wiring in to minimize holes in the bottom of the bed.
Shawn
Thanks! Unfortunately my 2014 doesn’t have stake pockets. Most importantly, Im never getting rid of this truck so the holes don’t bother me. Actually the only holes in the floor are for the diesel heater exhaust/fresh air pipes. and a 1/2” water tank low point drain. I did need to pop 2 holes in the rear part of the top rail due to a design flaw in the trailing edge of the 2 wheel well boxes. The battery box (drivers side)and diesel heater/tool box (passenger) that covers the wheel wells. Instead of rebuilding the boxes, in goes the holes! They are covered by the cap rails and I use grommets to protect the wires! Small price to pay I guess!
My lessons learned are an incredible tale of trial and error and lots of money!! Even with the best laid out plan, I changed a few things that I wished I thought of in the first version!
Best of luck with your build and dont forget to create a page so we can follow your progress! Oh, if you want a small form factor UV light for your water supply, dont buy guzzleH20’s expensive setup. I found that the manufacturer sells it online at Lowes! Shocked me too!
