Recent content by JayMacLR

I’m wanting to go something with Fuel Wheels. I’ll have to utilize spacers, but as long as you go with the hub centric and a reputable brand and quality you’ll be fine. I’ve had them on the LR before and no issues at all.

With work being so busy in retail not to much. I do have a pretty long list of mods coming in March however. I want to get 18”s and 275/65’s installed, bumpstop extention, roof rack (frontrunner), hidden winch bumper, winch, spod system, and ditch the rods and go with the IIDTool to go full...

This was my second one: a 2002 model same engine same body style.

No I sold that one back in 2009. That was a 1997 3.7L 2WD I had in high school. Thing could keep up with most 4x4’s back then loved it!

Back in 2006! Lol

Drawer #1 is completed. 22” drawer I have it to come right to the end of the gate. That gives me about a foot of dead space behind the drawer for extra holding that I can reach from the back pass door. P.S......I’m not a carpenter I won’t be using locking openers but I will be putting on a...

War Eagle! ;) we are half and half here lol. And thank you!

Added some ditch lighting:

Supports in, drawers next

Working on an MDF box in the rear, going to have box and drawer on right hand side with a slide out for table space at the bottom. On left hand side I’ll have it open to slide larger duffles, boxes, and equipment. Let me know your ideas! This is held in place right now in the existing trunk...

Unfortunately no, I went in under the hood, checked all fuel lines and vacuum lines, all seem great. I cleared the codes and they haven’t came back since. I’m keeping close eye on it though. And still doing research just in case it pops again.

Just finished up a couple days ago with the rotor and pads install up front. Riding like it just came off the lot. Come Tuesday I have a new suspension compressor coming hope to install that night. Anyone have any issues with the beauty rings on the lugs? These things are weak!

Currently working on these and replacing my front rotors and pads: Any recommendations on these codes?

Thank you! We’re you able to make it out here? I’m sorry I’m just now replying my notifications on the app hasn’t worked on here. I’m planning on going back Up there hopefully next week.

Mike I got them from Amazon, they are lightly tinted however I would recommend going darker. I can see the 3M tape behind it. Or of course going with the in channel option.