Recent content by BigBlueOx_TRD

Added a DIY diesel heater build to the LFD multi purpose window panel.

Getting some new upgrades to the camping set up at AVO today! Alu-Cab Gen 3r rooftop tent and Shadow awning. Can't wait to spend a night in the woods!

Merry CHRISTmas Everyone!

Headed to camp down south where the weather is a bit warmer.

Thanks Dale!

Installed the Rotopax onto the all new @lfd_off_road Mutli-Purpose Window Panel

Got the Rotopax fuel pak installed on the all new @lfd_off_road Multi-Purpose Window Panel

Thanks Dave!

This is perfect!

Thank you @genocache

That's pretty awesome! I've considered, at some point, getting a rear bumper with tire carrier and swing outs. If so, I'd like to install a water tank where the spare is. I've seen several really great DIY projects for this and it has turned out well. It's always great to have potable water on...

I sure did. If you look close on the sides of the angle iron you can see 2 holes in each piece. That's the mounting holes for the bolts to the roof rails. Then I drilled 6 holes down the center of the base for water to drain. In case of rain, washing the rig, or any other fluid concerns. Great...

We were tired of trying to perfectly get these 7 gallon water jugs on top of our roof rack and strapped down for our adventures. Not only that, but keeping them snug enough to not make noise on trails, etc. It only took one good beach trip and the jugs to move back and forth enough on the rack...

No need to apologize. You are completely right about the suction cups for phones, tablets, etc. They don't always hold like they should, especially in NC humidity, lol. The suction cups are only there for stability at the bottom, and greatly help with installation. The panels are mounted with 4...