Search results

alright figured out mounting for the bcdc 1225d, let’s get this bad boy wired!

little bit closer! Dual battery wiring is next.

Baja squadron sport spots added. Next up is addressing trans temps. Starting to save up for the rear bumper / tire carrier now. Then focus on the inside of the bed for awhile.

Tried to be cheap and use Milton fittings I had on hand for this project. Turns out it makes the system too long and hits the air box. An arb fitting and a cobbled together 90 degree elbow later. Gears are quiet and being broken in. Been to chicken to test lockers

Got this in as well. Tundra goes in next week for Eaton lockers and 5.29s

Got this thing in!

I just finished (Well is it ever finished?) Installing and RCR force 12 on my truck. (2020 Tundra) But I am left with the 2 triggers wires I am unsure what to do with. I had the thought of hooking up to the Reverse lights but I couldnt find a fuse to that. Give me some other ideas to hook...

Look forward to a report on the Ecoflow Wave 2 if you have the time.

The SDHQ portion of the kit was the mount for what is pictured above, and the switch panel. The rest is all Switch Pros. Does not have to be mounted there, just the mount I chose. There maybe other panels available and/or mounting elsewhere wont be hard. The only trick I can forsee is having...

Sorry I missed that! Almost the same truck.

Here is the front and back of the power distribution center. This is mounted in front of the driver side headlight right in front of the battery on the tundra.

That plate is made by SDHQ its part of this kit, https://sdhqoffroad.com/products/14-20-toyota-tundra-sdhq-built-complete-switch-pros-rcr-12-mount here is the plate by itself...

From the Panel to the switch's is a 4 wire connector. I was not smart / talented enough to depin the molex 150 connector to make fishing through the firewall easier so I fished the end that goes to the switch panel through the firewall. All of the accessories connect to one of two wire bundles...

In anticipation of gears and lockers going in I got the Sdhq switch panel and rcr force 12 installed 90% of the way. I have the wrong fuse tap for the ignition wire and I need to find a better way to route the power wire and it will be installed completely.

So in order to get a battery in there I need to move the steering reservoir. I have so far been unable to figure out what size hoses they are without removing them. Also, just got a qoute for 5.29s and Eaton Lockers. Thats gonna hurt the bank a bit, but parts are ordered. More coming soon!

How long have you had the decked system? What are your thoughts on it? Buy it again?

Got some stuff moved around in the engine bay today. Quality was top notch, install was mostly easy.

Ordered the SDHQ battery tray.

Little More complete of a diagram and parts. Pretty sure this is correct.

Starting to work on the dual battery kit set up. Ill use the SDHQ battery tray kit and then some redarc products. Pretty sure I got the fuses wrong for the SBI212D, they need to be 200 amp fuses. This will give me the majority of what I want. Trying not to hook up too much stuff in the...