Recent content by Berserker

My one gripe with the case I used is I can't fit my current air hose in it. The next largest Zarges case is too big for this use (shown in the stacking shot in the video). I'm looking at air hose options to fit in the case. You've had that Viair for quite a while.

Thanks- it was fun to make. Here's the diagram I came up with. Over the years I butchered the original switch harness to the point of uselessness for portability, so I spliced in a new 3-pin plug and started over. I couldn't find an appropriate wiring diagram online and turned several wires into...

Hello, fellow adventure travelers. Below is a quick overview of my portable ARB air compressor build. I've had this compressor for eight years and it was hard-mounted in my first two Jeeps. On my third build, I wanted a customizable solution wherein my Jeep isn't always burdened with my off-road...

If you're heading to Moab from the East I recommend you try the "Gateway to Moab" trail. It runs from Gateway, Colorado, around the La Sal mountains, and ends in Castle Valley, Utah just north of Moab. This video documents a trip I did through the area, including the only 4x4 road in Arches...

I ditched FB a few years ago and have been happy. I'm in the same boat as you- it's tough to find an active local community outside of FB groups.

It's been two years since I've wheeled KS Rocks without having to film an event. That place has gotten a lot harder over the years.

I'm game for a meetup. I ditched Facebook so these forums are the only way I can stay connected.

Hey guys. I'm new to OB. Konza Overland member as well. Over the summer I'm doing a Kansas Grasslands tour. So far I my destinations are Tallgrass Prairie, Cimmaron National Grassland, Konza prairie, and the Flint Hills. Any I should add?