Ram 2500 Power Wagon build (Clifford)

  • HTML tutorial

southtxpilot

Rank I
Launch Member

Member I

233
Fair Oaks Ranch, TX, USA
First Name
William
Last Name
Richardson
Member #

19585

I’m new to the site but have been building this truck for two years now. Lots done but every trip exposes more to do. My son named the truck Clifford because it’s “the big red dodge”. I took a sabbatical last year and went all over the US, Canada, and Alaska in Clifford.

2017 Ram 2500 Power Wagon w/ 6.4 hemi, rear limited slip, front and rear e-lockers, sway bar disconnect.
Sticker delete.
12,000lb Warn winch.
Magnaflow catback exhaust.
K&n intake.
Diablosport fully unlocked ecm with Hemifever tune.
Leitner rack.
Decked bed drawers.
ARB awning.
Tepui (over 90 nights!) tent replaced by Go FSR 80” tri layer.
BDS 4” lift with Fox shocks and twin steering.
Rhino wheels wrapped with 37” KO2’s.
Kleinn onboard air with horns. Air chuck on bumper.
Firestone bags with free floating Daystar cradles.
Switch Pros 8 channel controller.
AMP research steps and tailgate step.
Rigid lights; front bar, rock lights, scene lights on rack, and rear bumper lights.
Yukon 4.88 gears.
4’ firestick with Uniden off-road cb.
Hi lift jack.

Sure I’m forgetting some stuff. Next up is to buy a bigger pod from Leitner. I can carry rifles in there for hunting trips and hang my traction aids on the back. I’d also like to put a roof rack on it with round lights facing front. Here’s a few pics. The Tepui tent setup pic was from the Oshkosh air show campground this year.
IMG_2076.JPGIMG_2249.JPGIMG_2739.JPGIMG_2955.JPGIMG_2959.JPGView attachment 117821