Nissan Frontier Lift Options

[No Known Boundaries]

Cheers, all. Can anyone chime in with some suggestions on 2nd gen Frontier lifts (2011 Pro 4X double cab short bed). Requisites are as follows:
-2-3" (already looked at OME's 1.5")
-NO block lifts in the rear
-NO spacers in the front
-NO front diff drops

It would be used hard, so it has to be functional and purpose-built. Frontiers are just a bit trickier to find stuff for than the Taco. Thanks all!

 

[DanR]

As an Xterra owner, I know the struggle to find good lift components. The OME stuff is what I would recommend, I don't think you'll be able to match the quality for the price.

 

[Raul B]

Nistec. Check out xterra performance.

Sent from my SM-G930T using OB Talk mobile app

 

[The other Sean]

What he said...

Your main issue is the OEM upper control arms. anything over 2.5" of lift gives you coil bucket contact.

With that said, I'm running a titan swap using SPC upper arms, Dorman lowers, 1st gen tundra 5100 Bilsteins, 4 runner springs with custom top hats. I'm up about 3" from stock and have near 10" of wheel travel. I did that method because I didn't;t want to run a coil over with heim joints up here in MN. Many people use an extended travel aftermarket coilover.

In the rear, Alcan's or other suppliers could get you springs.

 

[will.shaw]

which lift kit is that?

 

[will.shaw]

i purchased the rough country after i read a review from this site for Nissan frontier lift kits